Remote Control Car Maintenance Tips
Remote Control Car Maintenance Tips
Remote control car racing has always been a wonderful hobby any one can get addicted to. Motoring fast is also one of the causes why so many people are interested in car racing. But using an RC car is not the same as driving an actual one. In addition to the fact that they are much smaller in size, RC cars are controlled by remote controls apparently. Remote or radio controlled car racing is an exiting event among hobbyists in many parts of the world. Remote control car racing creates exhilaration, whether you’re competing against the child in the neighborhood or seriously on the track.
The major distinction between a fuel-powered car and an electric car is the engine. The RC battery car has a motor and batteries. The car operates with electricity that makes the car run. The nitro RC controlled car consists of a specially made motor. The engine is run by fuel as in the case of an ordinary car. A specially made methanol based fuel is used for RC cars. Some other RC cars make use of gasoline. However such cars are bigger models and not fully hobby radio control cars.
Maintaining a well-functioning RC car is a tough task to do. Even though this hobby can take a good amount of time, in case you look back at your hard work towards the end, you won’t get disappointed at all. Many important things need to be checked on, and this bears on the wheels since they are always in contact with the wet ground. The front side spindles are to be looked at first and in case there is any slop on the tires, clean it immediately. Observing the tightness of the tiers after it becomes wet is vital. Test the wheels by shaking it and if you feel it is loose, pad or shim it instantly, and urgently replace if required.
Two ways are there to increase the grip of the RC car. First of all, you can control the suspension at the particular part. The same can be done by reducing the tensity of the spring, with a less viscous oil or with a shock piston having more number of holes. These last two measures allow oil to enter the carburetor and get used more promptly. Instead, you can alter the emplacement of the shock shaft proportional to the chassis. In case the shock absorber is mounted towards the end of the arm, the tire will be subjected to a force same to that of the whole spring.
If the atmosphere is very cold or dirty then you are likely to find that the one way bearing could become useless owing to the great becoming dirty or cold so looses its fluidness meaning the bearing to slip off. If such a situation arises, try to warm the car and gearbox up for about 5 to 10 minutes with the help of a small hairdryer, heater and you will see the problem disappears. If the problem occurs again then the first gear wheel will require removal and wd40 or alike applied to the shaft and bearing. Applying the wd40 ensure that the center and the shaft of the one-way bearing gets rid of all grease. After that you can use fresh grease but make sure that it is grease used on one way bearing. Removing the RC car’s gearbox is very easy but will take some time to learn.
Radio control trucks and cars that use electricity require rechargeable batteries to counterbalance the running time of your practice and duration of the race. As there are different kinds of batteries available in the market, ensure that you have the apt information about the required battery set for your remote control vehicle. Therefore, firstly identify the type of the battery. They are mainly the NiCD and NiMH ones. NiCD means nickel-cadmium whereas NiMH stands for nickel-hydride.
As part of a good maintenance, you can wash out the dirt and other unneeded deposits in your RC car after every race. This does not make you a determined person but keeping your RC vehicle this way will make you much more concerned about it. The best thing about conserving a motor for your remote control car is to understand that all engines will lose their spic-and-span and telling performance as time goes on. Just try to ensure that you spend money for cleaning it and keeping it in good running condition as though you bought the car a week ago.